■Snoot Set for S-2000
Set contents：Rubber Hood 52, W40°Filter・LE x 2 , Snoot Tube 10, Snoot Tube 26
The INON Snoot Set for S-2000 is an accessory for the INON ｢S-2000｣ to change beam angle. The various combination of packaged parts supports 6 different beam coverage with the following sophisticated effects
● To block extra diffused light eliminating backscatter
● To highlight a subject by illuminating the subject only
● To give a spotlight effect on a subject etc.
Various combination for different beam coverage
Various combination of packaged parts provides 6 different beam coverage to suit to a subject and intended effect.
|
|
|
To block extra diffused light eliminating backscatter
|
|
|
|
|
|
*Beam coverage is actual measured data by INON INC and could have variant depending on test condition.
*Always conduct test shots to familiar with the product characteristic before you take an important shot. When using the S-2000 in S-TTL Auto mode for spotlight effect of this product, center spot metering mode on a camera is recommended since average metering mode or multi pattern metering mode could wash out the center of an image. In case S-TTL Auto mode does not provide appropriate exposure, use Manual mode.
*Make sure to cool down the「S-2000」according to instruction manual/[Compatible battery, operational limitation on flashing] leaflet provided with the S-2000, to prevent overheating/degradation of light emitting part/inner components.
*When you entry with this product being attached on a strobe, make sure to evacuate remaining air inside of the Rubber Hood before you get underwater.
*Always extend the「Rubber Hood 52」when using the「Snoot Tube 10」or「Snoot Tube 26」together to prevent possible damage on light emitting part and/or inner circuit of the S-2000 etc.
